Your product
datasheet K-KFK-D

Product-Description

Flange ball valve K-KFK-D

Stainless steel

Compact face-to-face length

With DIN flange

DN 10-100

PN max. 40

Series

26 – PN 16 according to DIN EN 1092-1
28 – PN 40 according to DIN EN 1092-1

Temperature range

Standard: -10°C to +150°C
On request: -50°C to +250°C

Range of use

Liquids: Liquids group 1 and 2 according to PED 2014/68/EU Article 13
Gases: Liquids group 1 and 2 according to PED 2014/68/EU Article 13
As a matter of principle, the resistance to the flow medium must be ensured.

Technical specification

The K-KFK-D type ball valve consists of a 2-part body with a flange screwed in on one side, or a close-coupled flange. When using the ball valve as an end fitting, the direction of flow must be noted due to the constructional design. Up to nominal width DN 25, the stem is fitted from the outside by means of a fitting. Simple replacement of the stem seal is ensured by the fitting used. A stem seal in accordance with the German Technical Instructions on Air Quality Control (TA Luft) is available as standard from nominal width DN 32 and can be used, on request, up to nominal width DN 25 for an additional charge. Actuators can be attached by means of an extension kit. This retrofit requirement is available as standard.

Please ask separately, where requirements exceed the standard conditions of use listed in this data sheet. As a matter of principle, the operating and maintenance instructions, in particular the safety instructions must be observed! Operating and maintenance instructions as well as the approval certificates can be downloaded at www.von-scheven.de.
We reserve the right to carry out technical modifications.