Your product
datasheet DBA-D

Product-Description

3-way changeover ball valve DBA-D

Stainless Steel

With male thread

DN 4-40

PN max. 500

Series

02 – male thread on both sides for non-soldering compression fittings
with cutting ring DIN 2353 – light-duty series
03 – male thread on both sides for non-soldering compression fittings
with cutting ring DIN 2353 – heavy-duty series

Temperature range

Standard: -10°C to +90°C
On request: -50°C to +250°C

Range of use

Liquids: Liquids group 1 and 2 according to PED 2014/68/EU Article 13
Gases: Liquids group 1 and 2 according to PED 2014/68/EU Article 13
As a matter of principle, the resistance to the flow medium must be ensured.

Technical specification

Up to DN 25, ball valve type DBA-D consists of a block body, from DN 32 it consists of a forged body with connector screwed in on both sides. When using this ball valve, please note that, concerning the seal, this is a changeover ball valve. Pressure inlet must therefore be in the centre. Actuators can be attached by means of an extension kit. This retrofit requirement must be specified when placing the order (additional charge).

Please ask separately, where requirements exceed the standard conditions of use listed in this data sheet. As a matter of principle, the operating and maintenance instructions, in particular the safety instructions must be observed! Operating and maintenance instructions as well as the approval certificates can be downloaded at www.von-scheven.de.
We reserve the right to carry out technical modifications.