Your product
datasheet KSAE-DR-C

Product-Description

Ball valve KSAE-DR-C

Steel

With swivelling SAE flanges

DN 15-80

PN max. 420

Series

68 – Swivelling SAE flanges on both sides 3000 psi
69 – Swivelling SAE flanges on both sides 6000 psi

Temperature range

Standard: -10°C to +90°C
On request: -50°C to +250°C

Range of use

Liquids: Liquids group 1 and 2 according to PED 2014/68/EU Article 13
Gases: Liquids group 1 and 2 according to PED 2014/68/EU Article 13
As a matter of principle, the resistance to the flow medium must be ensured.

Technical specification

KSAE-DR-C type ball valve consists of a block resp. forged body with connector with male thread screwed in on both sides including SAE flanges. The flanges are of a swivelling design due to the threaded connection between the SAE flange and the ball valve fitting. Up to nominal width DN 25, the stem is fitted from the outside by means of a fitting. Simple replacement of the stem seal is ensured by the fitting used. A stem seal in accordance with the German Technical Instructions
on Air Quality Control (TA Luft) is available as standard from nominal width DN 32 and can be used, on request, up to nominal width DN 25 for an additional charge. Actuators can be attached by means of an extension kit. This retrofit requirement is available as standard from DN 32. Up to nominal width DN 25, this must be stated when placing the order.

Please ask separately, where requirements exceed the standard conditions of use listed in this data sheet. As a matter of principle, the operating and maintenance instructions, in particular the safety instructions must be observed! Operating and maintenance instructions as well as the approval certificates can be downloaded at www.von-scheven.de.
We reserve the right to carry out technical modifications.